Calibration and verification
|
The metrology service carries out a wide range of measuring equipment tests:
The service carries out metrological tests both of instruments manufactured by third parties and its own instruments. The company has a unique set of metrology equipment of its own development, allowing for attaining the meter accuracy class of ± 0.2% for gaseous media, ± 0.07% for liquids:
|
||
|
|
 |
 |
!
Department of metrological service sales accept applications by phone +7(863)203-77-85
Reference nozzle calibration rig on natural gas SPU-PG-2M
|
The calibration rig is used for calibration, verification and testing of gas flowmeters and meters of different operating principles in the gas flowrate range from 1 to 16000 m3/h. Measurement error is ± 0.3%
Reference calibration and verification multigas rig SPU-MG-4M
|
The reference nozzle calibration rig is used for calibration, verification and testing of gas flowmeters of different operating principles in the flow rate range from 0.2 to 2500 mЗ/h.
Flow-metering calibration rig PURS-V-1
|
The PURS-V-1 unit is used for calibration of water meters with the upper measurement limit up to 217.2 mЗ/h with value of the relative error of no more than 0.3%.
Reference nozzle calibration rig on air UPSG-1600
|
The UPSG-1600 unit is used for calibration of industrial gas meters with the upper measurement limit up to 1600 mЗ/h. The unit use is regulated by the calibration diagram of GOST R8.618-2006, where the unit is classified as working references of the second category.
Bell-type calibration rig KPU-2000
|
The bell-type calibration rig is used for reproduction of the given volume and volumetric gas flow rate from 0.01 to 100 m3 /h. Measurement error is ± 0.2%.
